| 詳細參數 | |||
|---|---|---|---|
| 品牌 | Triconex | 型號 | AI3351 |
| 結構形式 | 模塊式 | 安裝方式 | 控制室安裝 |
| LD指令處理器 | 硬PLC | 功能 | 處理器模塊 |
| 工作電壓 | 電源組24VDC | 輸出頻率 | 10/100Mbps |
| 產品認證 | CE | 加工定制 | 否 |
| 重量 | 7.13磅 | 產地 | 美國 |
TRICONEX AI3351
AI3351應將互聯設備共地；否則，如果接收端有較高共模輸入，就有可能損壞接收端器件。
多數情況下，連接AI3351通信鏈路時只需簡單地用一對雙絞線將各個接口的“A”、“B”端分別連在一起，而將信號地空懸——這種連接方法在許多場合是能正常工作的，但應注意以下兩個問題：
A
(1)共模干擾問題：AI3351接口采用差分方式接收輸入信號，并不需要相對于某個參照點來檢測信號，系統只需檢測兩根輸入線之間的電位差就可以了。但人們往往忽視了接收器有一定的共模電壓范圍，RS-485接收器共模電壓范圍為-7～+12V，只有滿足上述條件，整個網絡才能正常工作。當通信線路中模電壓超出該范圍時就會影響通信的穩定可靠，甚至損壞接口。
(2)AI3351電磁輻射問題：驅動器輸出信號中的共模部分需要一個返回通道，如果沒有一個低阻的返回通道(信號地)，就會以輻射的形式返回源端，整個總線就會像一個巨大的天線向外輻射電磁波。
Ai3351 shall ground the interconnected equipment together; Otherwise, if the receiver has a high common mode b, the receiver device may be damaged.
In most cases, when connecting the ai3351 communication b, it is only necessary to simply connect the "a" and "B" ends of each interface with a pair of twisted pair to suspend the signal in the air - this connection b can work normally in many occasions, but the following two problems should be paid attention to:Common mode interference problem: the ai3351 interface receives the b signal in a differential way, and does not need to detect the signal relative to a reference point. The system only needs to detect the potential difference between two b lines. However, people often ignore that the receiver has a certain common mode voltage range. The common mode voltage range of RS-485 receiver is - 7 ~ + 12V. The whole network can work normally only if the above conditions are met. When the common mode voltage of the communication line exceeds this range, it will affect the stability and reliability of the communication, and even damage the interface.
Ai3351 electromagnetic radiation problem: the common mode part of the driver output signal needs a return channel. If there is no low resistance return channel (signal ground), it will return to the source in the b of radiation, and the whole bus will radiate electromagnetic waves outward like a huge antenna.
我們的優勢
1. Bently Nevada：3500 系列/3300 系列
2. ABB：PLC & DCS 模塊，DSQC 系列，Bailey INFI 90
4. GE FANUC：IC693/IC695/IC697/IC698 / IS200 / DS200
5. Honeywell：10100/2/1 , 51304511-200, ACX631 51198947-100B, 80363969-150 等
6. Woodward:9907-164/162/167, 5464-654, 9907-014
7. Invensys Triconex: 3008, 3503E, 4351B, 36 等
8. ICS TRIPLEX: T8480, T8310, T8461, T8431, T8311..
其他品牌: Foxboro / Schneider / EPRO / Emerson/ Siemens MOORE,6ES5 / 6GK / 6DD / 6AR
TRICONEX 3607E
TRICONEX 3623T
TRICONEX 3636R
TRICONEX 3664
TRICONEX 3700A
TRICONEX 3700A
TRICONEX 3700A
TRICONEX 3704E
TRICONEX 3704E
TRICONEX 3805E
TRICONEX 3805E
TRICONEX 3805E
TRICONEX 3805E
TRICONEX 3805E
TRICONEX 4200
TRICONEX 4201
TRICONEX 4329
TRICONEX 4329
TRICONEX 435*425*60
TRICONEX 4351B
TRICONEX 4400
TRICONEX 4500
TRICONEX 4508
TRICONEX 4609
TRICONEX 9561-810
TRICONEX 9563-810
TRICONEX 9563-810
TRICONEX 9563-810
